Table of Contents
Advertisement
ID61/62 Series Panel - Installation, Commissioning & Configuration Manual
2
or
2
8
6
2
or
2
8
b. XON/XOFF - software control of data flow
c. HARDWARE
.
1
This option is for datalinks that use 'Request to Send' (RTS)
1
and 'Clear to Send' (CTS) hardware status line commands.
If the RS232 port is set to THIRD PARTY, the available
'Third Party' options are:
d. Full duplex (default option).
e. Half duplex.
If the RS232 port set to GSM MODEM, refer to Section
5.5.4.9 for details.
1 From the Peripheral Options screen, press the '
button on the numeric keypad to select the RS232
Communications port option. The RS232 Protocol
setup screen is displayed first:
[Setup]
RS232 Protocol =
> : Change
2 Press the '
/
2
options until the Print Control screen is displayed.
[Setup]
Print Control =
> : Change
3 Press the '
' button to toggle between 'BASIC',
6
'XON/XOFF' or 'HARDWARE'.
[Setup]
Print Control =
> : Change
[Setup]
Print Control =
> : Change
4 Press '
' to return to the Peripheral Options menu
4
screen.
5.5.4.8 Third Party Datalink Monitoring
This function is only selectable if Third Party was selected
at the RS232 Protocol screen. Monitoring of the third party
datalink can be enabled or disabled as follows:
1 From the Setup menu screen, press the '
on the numeric keypad to select the RS232
Communications port option. The RS232 Protocol
setup screen is displayed:
[Setup]
RS232 Protocol =
> : Change
2 Press the '
/
2
Peripheral Options until the Data Link Monitoring
screen is displayed.
[Setup]
Data Link Monitoring =
> : Change
55
PRINTER
: More
< : Exit
' buttons to scroll through the
8
BASIC
: More
< : Exit
XON/XOFF
: More
< : Exit
HARDWARE
: More
< : Exit
2
THIRD PARTY
: More
< : Exit
' buttons to scroll through the
8
ENABLED
: More
< : Exit
997-457-000-8, Issue 8
January 2010
'
2
' button
Advertisement
Table of Contents
