Table of Contents
Advertisement
ID61/62 Series Panel - Installation, Commissioning & Configuration Manual
2
or
2
8
CAUTION:
This product is not compliant
EN
EN
12094-1
12094-1
with EN 12094-1.
!
!
Fire extinguishing installations in
Europe are required to be certified as
compliant to this standard.
2
or
2
8
5.7.2 Filter-by-Type
This option is available with the Fire, Fault, Pre-alarm
and the Extinguishing System rules. The Filter-by-type
option has five selections with Fire and Fault categories:
ANY, OTI, AVS, MCP and MON and three with Pre-alarm:
ANY, OTI and AVS. The Filter-by-type option, when used
with the Extinguishing System category has seven
selections: Smoke/Heat, Sensor and MCP/ZMX, VIEW/
Sensor, Any Two Zones, Any Two Sensors, Any Single
Sensor and Any Single Module. Refer to Section 5.7,
Control-by-Event Output Rules for further information.
To select the type filter for Fire, Fault or Pre-alarm:
1 Press the '
select the Filter option from the menu below.
CBE Rule:01
4:Silence
2 Press the '
CBE Rule:01
: Change Filter Type
5
3 Confirm the selection by pressing the '
the selection, press '
Extinguishing System
To select the type filter for Extinguishing System:
1 Press the '
select the Filter option from the menu below.
CBE Rule: 01
2 Press the '
CBE Rule:nn
: Accept
5
3 Confirm the selection by pressing the '
the selection, press '
83
' button (using the numeric keypad) to
2
1:Type
2:Filter
5:Interrupt
/
' buttons to select the required filter.
2
8
Current Filter Type =
: Accept
' button.
4
' button (using the numeric keypad) to
2
1:Type
2:Filter
8:Soak Timer
9:Zones
/
' buttons to select the required filter.
2
8
Ext. Filter Type =
[One sensor]
: Change Filter Type
' button.
4
997-457-000-8, Issue 8
3:Evac
: More
[ANY]
< : Cancel
' button. To cancel
5
< : Cancel
' button. To cancel
5
January 2010
Advertisement
Table of Contents
