Introduction; Features - Honeywell SMX-AUS User Manual

2

Introduction

Fig. 1: Fire alarm control panel SMX-AUS

2.1 Features

Following are some of the features of the fire alarm control panel:
•
Connections to one or two Signalling Line
Circuit (SLC) loops (CLIP protocol)
•
Onboard alarm, fault, and programmable relays
•
Multi-colour touch screen display
•
RS485 connections for wiring annunciators
• RS232 connection for printer
• Firmware upgrade or downgrade through USB
•
Portable configuration settings (through USB or
Bluetooth)
•
Backing up the event logs (through USB or
Bluetooth)
•
Multi-level access control (Level 1, 2, 3, and 4)
•
All sounder deactivation via programming
•
Auto-learning capability
•
Configuration options: USB storage device,
mobile app, and the panel interface
NS-MN-0032 / 11.2020
The fire alarm control panel SMX-AUS is available with:
•
Metal enclosure with glass door and MCP
•
1 loop and 2 loops (CLIP protocol)
•
5-inch touch screen
•
LED indicators to know the status of power, system etc.
•
Supports max. 160 zones (system-wide)
•
10,000 event logs for SMX-AUS
•
View pulse width (PW) values
• View voltage and analogue values
• Onboard monitored input for supervisory
•
Set date and time
•
Walk test - with all sounders / one selective
sounder/ without any sounder options
•
Point, Zone, Logic Zone, Output Group and
programmable Relay Disablements
•
Alarm Delay Facility (ADF) and Alarm
Verification Facility (AVF)
•
Up to 4 Fire Fan Control groups using SLC loop
modules, along with duct detector support and
Fire Fan Control Panel (FFCP) on fascia
•
Occupant Warning System (OWS) support
User's Guide SMX-AUS
•
160 programmable zones (system-wide)
•
Door MCP for fire alarm
• Add-on Relay I/O Card with Alarm Routing
Equipment interface and one programmable
Relay
•
100 logic zones with AND, OR, NOT logic
conditions
•
Non-latched supervisory action for detectors
and modules
• Configurable alarm sensitivity levels for smoke
and multi sensors
•
Fire-Trip latching for relays and control
modules, until Fire Mode Reset
•
Integration to external systems using printer
port
9