Connecting The Adeept Arm Drive Board And The Computer; Install Ch341Ser Driver - ADEEPT Robotic Arm Manual

5.Connecting the Adeept Arm Drive Board and the
computer
(1)Connecting the
You need to use USB Cable to connect the
computer.As shown below:
(2) Select the Arduino Uno development board in Tools
Open Arduino IDE under Tools—>Board.Select Arduino UNO in the list.

(3)Install CH341SER driver

1. Open the Arduino IDE, in the Port on the Tools toolbar, you will see that the
serial port cannot be accessed, which means that you have not installed the serial port
driver.
Adeept Arm Drive Board
22
and the computer
Adeept Arm Drive Board
to the