How To Start The Imitation Mode Of Robotic Arm; Introduction To Imitation Mode - ADEEPT Robotic Arm Manual

7.Next, unplug the USB cable connected to the robotic arm.Powered by a fully
charged battery.
8.After completing the above preparations, gently support the robotic arm and
then turn on the power. You will see the working status of the current situation and the
number of the remaining motions the robotic arm needs to be record display on the
OLED.At this point, the robot arm goes into imitation mode.
【Note】：
When learning this lesson, you must first do some configuration according to part
8 of lesson 0, otherwise you will encounter many errors when you download the
program to the Adeept Arm Drive Board.

12.3 How to start the imitation mode of robotic arm

12.3.1 Introduction to imitation Mode

In the imitation mode, the robot arm can record different motion track or actions
(up to 333 can be recorded, the recorded can be written into EEPROM), After
re-powering, press the "BUTTON" for more than 8 seconds to enter the sport mode.
In the motion mode, the working status of each servo will be displayed on the OLED,
and the manipulator will automatically perform the previously recorded motion track
or actions.
167