The Method Of Reconnecting The Gwblock Graphical Editor - ADEEPT Robotic Arm Manual

8.3 The method of reconnecting the GwBlock
graphical editor
In the following cases, you need to reconnect to the GwBlock graphical editor:
[1] When you close the GwBlock editor.
[2] When you close the Adeept Arduino Robot window.
[3] When you restart the computer.
[4] When you log in to the GwBlock website again.
[5] When you close the Arduino IDE.
(1) Before doing the experiment, you must first connect the Arduino
development board to the computer.
(2) First,
AdeeptRoboticArmforArduinoV3_5, after opening, as shown below:
open the folder
121
we provide to the user: