Table of Contents
Advertisement
4.6.7.d. Set IPv6 RADIUS Server
On the RADIUS Configuration Menu, pressing "P" opens the Set IPv6
RADIUS Server Menu, as shown in Fig. 4-6-28. On this screen, you can
configure access setting to RADIUS server that is used in login
authentication.
PN28160i Local Management System
System Security Configuration -> Set IPv6 RADIUS Server Menu
NAS ID: Nas1
Index Server IPv6 Address
----- ----------------------------------------
1
::
2
::
3
::
4
::
5
::
-------------------------------- <COMMAND> -----------------------------------
Set [N]AS ID
Set Server [I]Pv6
[Q]uit to previous menu
Command>
Enter the character in square brackets to select option
Screen Description
NAS ID:
Shows the authentication ID (NAS Identifier).
Server IPv6
Shows the IPv6 address of RADIUS server. :: is displayed because no
Address:
address is set on shipment.
Available commands are listed below.
N
Set a NAS ID (NAS Identifier).
Press "N." The command prompt changes to "Enter NAS ID>." Enter NAS ID within 16
one-byte characters.
I
Set an IPv6 address of RADIUS server.
Press "I." The command prompt changes to " Enter RADIUS server index>." Enter a
RADIUS server entry number between 1 and 5. The command prompt changes to "
Enter new server IPv6 address>." Enter an IPv6 address.
Q
Return to the previous menu.
Fig. 4-6-28 RADIUS Configuration
94
Advertisement
Table of Contents
