Table of Contents
Advertisement
4.6.3.m. SNMP Trap Receiver Configuration
On the SNMP Configuration Menu, pressing "T" opens the SNMP Trap
Receiver Configuration Menu, as shown in Fig. 4-6-18. On this screen, you can
configure the SNMP trap receiver settings.
PN28160i Local Management System
SNMP Configuration -> SNMP Trap Receiver Configuration Menu
Trap Receiver List:
No.
Status
---
--------
1
Disabled
2
Disabled
3
Disabled
4
Disabled
5
Disabled
6
Disabled
7
Disabled
8
Disabled
9
Disabled
10
Disabled
-------------------------------- <COMMAND> -----------------------------------
Set Receiver [S]tatus
Set Trap [T]ype
[Q]uit to previous menu
Command>
Enter the character in square brackets to select option
Fig. 4-6-18 SNMP Trap Receiver Configuration
Screen Description
Trap
Shows the IP address and the community name for the current trap
Receiver List:
receiver.
No.
Status
Type
IP Address
Type
IP Address
----
---------------
v1
0.0.0.0
v1
0.0.0.0
v1
0.0.0.0
v1
0.0.0.0
v1
0.0.0.0
v1
0.0.0.0
v1
0.0.0.0
v1
0.0.0.0
v1
0.0.0.0
v1
0.0.0.0
Set Receiver [I]P
Set Receiver [C]ommunity
Shows the entry number for the trap receiver.
Shows the trap sending setting.
Enabled
Sends traps.
Disabled
Does not send traps.
Shows the trap type.
v1
Sends SNMP v1 traps.
v2c
Sends SNMP v2c traps.
Shows the IP address of a trap receiver.
69
Community
--------------------------------
In[d]ividual Trap Config
Set Receiver I[P]v6
Advertisement
Table of Contents
