Table of Contents
Advertisement
Available commands are listed below.
I
Set/edit the IP address.
Press "I." The command prompt changes to "Enter IP address>." Enter an IP address
for the Switching Hub.
M Set/edit the subnet mask.
Press "M." The command prompt changes to "Enter subnet mask>." Enter a subnet
mask for the Switching Hub.
G
Set/edit the IP address of the router for the default gateway.
Press "G." The command prompt changes to "Enter new gateway IP address>."
Enter the IP address of the router, set as the default gateway.
A
Set the IP address, subnet mask and default gateway in succession.
Press "A." The command prompt changes to "Enter IP address>." Enter the IP
address of the Switching Hub. Then, the command prompt changes to "Enter
subnet mask>." Enter the subnet mask. Then, the command prompt changes to
"Enter new gateway IP address>." Enter the IP address of a router, used as a default
gateway.
Q
Return to the previous menu.
Note: This item must be set in order to use the SNMP management
functionality and to enable a remote connection by Telnet or SSH. Any
IP addresses on the local network must be unique and no duplication
is allowed. If you are unsure, consult the network administrator.
42
Advertisement
Table of Contents
