Table of Contents
Advertisement
Available commands are listed below.
N
Show the next page.
Press "N." The screen shows the next port.
P
Show the previous page.
Press "P." The screen shows the previous port.
E
An EAP Packet forwarding can be assigned to each port.
Press "E." The command prompt changes to "Select port number to be changed>."
Enter a port number you wish to change. Press "0" to change the settings of all
ports at a time. Then, the command prompt changes to " Enable or Disable EAP
packet forwarding for port # (E/D)>." Press "E" to enable the function. Press "D" to
disable it. As the change is applied, the display on the screen is updated
automatically.
A
A name can be assigned to each port.
Press "A." The command prompt changes to "Select port number to be changed>."
Enter a port number you wish to change. Press "0" to change the settings of all
ports at a time. Then, the command prompt changes to "Enter port name string>."
Enter a name you wish to assign. When you complete the setting change, the
display on the screen is automatically updated.
J
Enable/disable the jumbo frame forwarding function.
Press "J." The command prompt changes to " Enable or Disable jumbo status
(E/D)>."
Press "E" to enable the function. Press "D" to disable the function.
Q
Return to the previous menu.
Note: The screen shows the port status; however, the status is not
automatically updated. To display the latest status, press any key.
80
Advertisement
Table of Contents
