Default Program - VETRON 5064 Service Manual

04. COMMISSIONING & WELDING

02. DEFAULT PROGRAM

In order to enable welding immediately after delivery or to test your machine, you can find
a pre-adjusted program, also referred to as "default program", under program number P000.
The default program is a continuous welding program at constant speed with the following parameters:
» 001 Program name
» 002 Continuous Technology
» 003 Wheel number
» 004 Gap dimension
» 005 Generator power
»008 Speed
» 011 Pressure (only with 25mm)
» 014 Lifting height (wheel lifting)
» 016 Puller / Speed
» 201 Ultrasound power stage 2
» 204 Startup delay
» 205 Start / end speed
» 206 Acceleration
» 207 Di erential speed
» 208 Deceleration
» 209 Backward welding after stop
» 210 Forward welding after stop
» 211 Generator deactivation time after pedal-0
» 212 Gap increase after pedal-0 until stop
» 213 Lifting delay
» 214 Wheel type
» 215 Wheel – equivalent width
ADVICE!
You may never change or overwrite the default program! The default program was specifically custo-
mized for the provided welding sample. If you would like to generate a new program suitable for your
material, proceed as described under 04.01. NEW PROGRAM.
If you use your machine for the first time, or if you reset the operating program, the default pro-
gram is automatically called up after the determination of the upper and lower reference points
(chapter 04.06). Otherwise, activation follows the description under 04.10. CHANGE PROGRAM.
02/2021
26
VETRON 5064 Welding Machine
W13003
0,02mm
60%
2 m/min
60%
3,0mm
+0%
10%
0,2 sek
10%
0,05sek
+0%
0,2 sek
0,0mm
0,0mm
90%
0,1mm
0,0 sek