VETRON 5064 Service Manual page 45

DISPLAY
» ERROR MASSAGES
E20 Foot motor
E21 Pressure motor
E22 Anvil motor
E23 Sonotrode motor
E25 GEN. UEBERLAST
E26 US.GEN.NO POW.
04. COMMISSIONING & WELDING
STEP
Cable broken, bad connection, Stepdriver
multifunction
Material welding no longer takes place or with
interruption
Power supply or control for generator is inter-
rupted
16. ERROR MESSAGES DURING WELDING
SOLUTION
Restart, check cables
» Check coaxial plug connection from genera-
tor to converter
» Replace sonotrode unit (module)
Check if:
» Generator is turned on
» Generator plug is inserted in the connector
strip below the table top
» Check connector on generator including
adapter (interface). Replace interface if
necessary
» Check generator connector on fan switch. If
necessary, replace fan switch or generator
connection cable
» Check B2 plug connection to fan switch. If
necessary, replace fan switch or connection
cable.
» Check B2 connection on the Vetron control
YSC-8340 and replace control or connection
cable if necessary.
VETRON 5064 Welding Machine
-2-2
02/2021
43