Table of Contents
Advertisement
03. COMMISSIONING & WELDING
02. DEFAULT-PROGRAMM
In order to enable welding immediately after delivery or to test your machine, you can find a
pre-adjusted program, also referred to as "default program", under program number P000.
The default program is a welding program with the following parameters:
»001 Program name
»004 Gap dimension
»006 Tape air time
»010 Cold Air
»012 Tape length 1A
»013 Tape length 1B
»014 Start feed speed
»015 Start speed
»016 Acceleration
»017 Welding speed
»019 Di erential speed
»020 Normal air
»021 Welding heat
»022 End speed
»023 Tape length 2
»024 Nozzle back after cutting
»025 Lift delay
»026 Wheel height by wheel lifting
»027 Pre Heat
»028 Pre Heat air
»029 Stop to Nozzle Out
»030 Post to heat
»031 Stop gap
If you use your machine for the first time, or if you reset the operating program, the default program
is automatically called up after the determination of the upper and lower reference points. Otherwise,
activation follows the description under 03.10. CHANGE PROGRAM.
02/2021
20
Vetron 5374 HotAir-Welding
0,02 mm
1,0 sek
AUS
41,7 mm
9,6 mm
1,8 m/min
84 %
0,8 sek
1,8 m/min
0 %
35 l/min
400°
71 %
43,2 mm
1,0 sek
0 sek
16 mm
200°
20 l/min
1,0 sek
4,0 sek
12 mm
NOTICE:
You may never change or overwrite the default program!
If you would like to generate a new program suitable for your ma-
terial, proceed as described under 04.01. NEW PROGRAM.
Advertisement
Table of Contents
