VETRON 5064 Service Manual page 73

EXPLANATION
Upper end position of the puller
Lower end position of the puller
Diameter of the puller wheel
Puller speed during acceleration
Puller speed during lowering
Delay between two amplitudes order during dynamic welding
Puller wheel rotates during the lowering of the puller device
When the operating program is overwritten and/or if the control is updated, the version
number is automatically updated
Hardware version
Serial number of the machine
1 = Steel sonotrode | 2 = Titanium sonotrode
hours
hours
The number of times the cylinder has been operated, how many strokes the machine has made
Set current:
1 = lowered / cold
2 = full current/ warm
1 = power saving mode on
2 = power saving mode o
02/2021
VETRON 5064 Welding Machine
71