VETRON 5064 Service Manual page 71

EXPLANATION
Pedal position, you can adjust it if necessary
Delay between discharge of compressed air and anvil lifting
Max welding feed
Limit with how much % the generator of the max. power works
Minimum gap of the steel sonotrode
Minimum gap of the titanium sonotrode
Stepper motor pressure, adjustable, stepper motor version
Di erential speed between anvil and sonotrode
Diameter of the sonotorde
Diameter of the zero wheel (required for sensor calibration, stepper motor version)
Number of the teeth of the gears on the sonotrode
Maximum value for P014/Anvil is in the upper end position
Advice:
These values shouldn't be changed!
Referenz position from puller
02/2021
VETRON 5064 Welding Machine
69