Commissioning & Welding; General Information About Welding | Welding Principle - VETRON 5064 Service Manual

04. COMMISSIONING & WELDING

01. GENERAL INFORMATION ABOUT WELDING | WELDING PRINCIPLE

GENERAL INFORMATION ABOUT WELDING
The functions listed under the "Welding" menu item are in particularly provided for production. De-
pending on the program selection, you can view all relevant functions and settings on the display by
pressing the parameter button.
In the WELDING operating mode, you can select the following technologies via the program selection
(chapter 03.10., Change program)
01. CONTINUOUS WELDING (chapter 04.02 & 04.02.01)
02. INTERVAL WELDING(chapter 04.02.02)
03. SPOT WELDING (chapter 04.02.03)
04. CUT & SEAL (chapter 04.02.04 & 04.02.05)
05. PROGRAM CHAIN (chapter 04.03)
WELDING PRINCIPLE
The vibrations of the sonotrode "condense" the material to be joined in the seam area. During
this welding process, the material is heated, compressed and transported at the same time
(= seam generation).
Please observe the following requirements for an optimum welding result:
» Select material, which is weldable (thermoplastics) and clean in the seam area. Furthermore,
the material to be welded must be suitable for processing using the VETRON 5064 with respect
to thickness and consistency.
» Select the welding wheel suitable for your purposes and make sure that pressure, welding
power, welding speed, and welding gap are correctly adjusted.
ADVICE:
The material to be welded and the ambient temperature are decisive for all welding
equipment settings. For this reason, optimum settings can be determined using weld tests
only.
02/2021
VETRON 5064 Welding Machine
25