VETRON 5064 Service Manual page 75

EXPLANATION
Set current:
1 = lowered / cold
2 = full curretn/ warm
Rotation direction of the stepper motor, you can adjust it if necessary
1 = Any machine function can be activated via USB stick only
0 = Any machine function can be activated without USB stick
This parameter can be changed via USB stick only
Rotation direction of the stepper motor, you can adjust it if necessary
–
You can select between: OFF | ELECTRIC | AIR
You can select between: 25 mm | 45 mm
You can select between: 1. = ELECTRIC | 2. = AIR
Automatic welding function: 0 = OFF | 1 = ON
Is the determined nominal and actual value of the sensor on the magnetic strip not the same, the parameter controls the height to
the same value.
You can choose: GERMAN | ENGLISH | FRENCH | SPANISH | ITALIAN
brightness limit
Gap correction between wheel and sonotrode
1 = Reset height measuring system parameters
2 = Reset factory settings (reset all informations and programs)
1 = power saving mode on
2 = power saving mode o
02/2021
VETRON 5064 Welding Machine
73