Table of Contents
Advertisement
Network Settings Panel
In the Network Settings panel (see figure 33,
subnet mask, and gateway address for your FOX3, and turn DHCP On and Off.
To set the IP addresses:
1.
Click EDIT (see figure 36 [left],
Settings panel opens to allow edits (right).
Figure 36.
2.
Edit the network settings as desired:
a.
Click the DHCP switch (
the unit configures its IP address and other network settings from the DHCP server.
The default is Off.
b.
To set any of the addresses (IP Address (
address (
3.
When finished editing, click out of the field and click SAVE to confirm your changes or
CANCEL to close the window without making changes. Clicking the X in the upper-right
corner of the screen also closes the window.
Firmware Panel
The Firmware panel (see figure 33,
version and the date it was last updated. Update the firmware on the FOX3 SR 201 from
this panel (see
files).
To update firmware:
1.
In the Firmware panel, click the SELECT
FILE button.
2.
In the Open dialog box, browse to locate
the new firmware file on your computer (by
default the file is stored at C:\Program
Files (x86)\Extron\Firmware\
FOX3 SR 201 after being downloaded
from the Extron web page).
) in the Network Settings panel. The Network
1
Network Settings Panel
) to toggle DHCP on and off. When DHCP is enabled (On),
2
), click in the desired field and enter the address.
5
, on page 41) displays the current firmware
4
Software/Firmware Installation
FOX3 SR 201 Scaling Receiver • Internal Web Page
on page 41), set the IP address,
3
), Subnet mask (
), and Gateway
3
4
on page 31 to download the firmware
Figure 37.
Firmware Panel
43
Advertisement
Table of Contents
