Table of Contents
Advertisement
SFP module and LEDs
H
WARNING:
The devices output continuous invisible light (Class 1 rated), which
may be harmful to the eyes; use with caution. Plug the attached dust cap into the
optical transceiver when the fiber optic cable is unplugged.
AVERTISSEMENT : Le produit émet une lumière invisible en continu (conforme
à la classe 1) qui peut être dangereux pour les yeux, à utiliser avec précaution
Branchez la protection contre la poussière dans l'ensemble émetteur/récepteur
lorsque le câble fibre optique est débranché.
NOTES:
Ensure the proper fiber cables for the transmitter and receiver pair are used.
•
Typically, singlemode fiber has a yellow jacket and multimode cable has an
orange or aqua jacket.
•
See figure 3 for fiber cable connections. Connect the transmitter to a receiver in
one of three ways:
One way (transmitter to receiver) only, connect transmitter Outputs A (
•
receiver Inputs A (
•
Two way (transmitter to receiver and return), connect transmitter Outputs
A (
) to receiver Inputs A (
1
receiver Inputs A (
•
Output B is available to transmit a 4K @ 60 Hz uncompressed signal when
the FOX3 4K @ 60 Hz Uncompressed Video LinkLicense is purchased.
Port A Out (required) — For all one-way video, audio,
1
and serial communications from the transmitter to the
receiver, connect a fiber optic cable to the Out LC port.
Connect the opposite end of this fiber optic cable to
the Port A In LC port on the receiver or to any other
compatible Extron FOX3 device.
Port A In (optional) — For one-way U serial
2
communications from the receiver to the transmitter,
connect a fiber optic cable to the In LC port.
Connect the opposite end of this fiber optic cable to
the Port A Out LC port on a receiver or to any other
compatible Extron FOX3 device.
•
Transmit Optical OUT LED lights solid green when
powered and lights off when there is no power on the
endpoint.
Receive Optical IN LED lights solid green when light is
•
present and lights off when there is no power or light
present.
Reset button — Initiates three levels of resets (1, 4, and 5). Use a pointed stylus,
I
ballpoint pen, or small screwdriver to access the recessed button (see
on page 16 for detailed reset information).
— (see figure 2)
).
1
) and connect transmitter Outputs A (
1
).
2
FOX3 SR 201 Scaling Receiver • Installation
) to
1
) to
2
OUTPUTS
A
B
OUT
IN
OUT
IN
Transmitter
1 1
2 2
2 2
1 1
INPUTS
B
A
Receiver
OUT
IN
OUT
IN
Figure 3.
Fiber
Cable
Connection
Reset Modes
7
Advertisement
Table of Contents
