Table of Contents
Advertisement
Operation
This section details the operation of the FOX3 SR 201 scaling receiver, including:
•
•
•
•
•
•
•
Front Panel Features
A
A
A
Figure 8.
A
B
C
D
E
Operations
After the transmitter, receiver, and the connected devices are powered up, the system is fully
operational. If any problems are encountered, ensure all cables are routed and connected
properly.
NOTE: Ensure that the video source and display are properly connected to the FOX3
Configuration and operation of the system is accomplished via
Control
Software
Front Panel Features
Operations
Using the On-Screen Menu System
Reset Modes
Front Panel Lockout (Executive Mode)
Configuration
Audio Configuration
INPUT
CONFIG
SIGNAL
HDCP
B
B
B
C
C
C
FOX3 Scaling Receiver Front Panel Features
Power LED — Lights when the unit is receiving power and is operational.
Configuration port — This USB mini-B port is used to configure the unit and to
update firmware.
Input LEDs
Signal LED — Lights when the unit detects an input video signal.
•
•
HDCP LED — Lights when the input signal is HDCP encrypted.
Menu and Enter buttons — Press these buttons to access and navigate the on-
screen display menu system.
Navigation buttons — Press these buttons to navigate through the on-screen display
menu system or change settings.
transmitter and receiver, and power is applied to the FOX3 devices and the display
before power is applied to the video source. If the other devices are not turned on
before the video source, the image may not appear.
(see page 21), the
Internal Web Page
(see page 31).
MENU
FOX3 SR 201
ENTER
D
D
D
E
E
E
SIS Configuration and
(see page 40), and
Configuration
FOX3 SR 201 Scaling Receiver • Operation
12
Advertisement
Table of Contents
