Table of Contents
Advertisement
Power LED — The lit LED indicates power is applied.
B
Audio output — This 5-pole, captive screw port outputs the transmitted, unamplified,
C
line level analog audio (see
connector).
NOTE: If embedded digital audio is present on the HDMI output, this analog audio
connector outputs audio unless embedded audio is in multi-ch format.
HDMI output — Connect a video display to this HDMI output port with a maximum
D
resolution of 4096x2160 @ 60 Hz, 8-bit, 4:4:4 chroma sampling (see
Connectors
on page 8 to use the included Extron Lock-It Lacing Bracket).
Control RS-232/IR port (see
E
signal, a modulated or unmodulated IR signal, or both to this 5-pole captive screw port
for bidirectional RS-232 and IR communication (see
page 11 to wire the connector).
NOTE: If only one fiber optic cable is connected (see
RS-232 or IR reports from the controlled device cannot be recieved. To receive
responses from the controlled device, two fiber optic cables must be connected.
Remote RS-232 — For serial control of the receiver, connect a host device, such as
F
a computer or touch panel control, via the three poles (Tx, Rx, and G) of this 3-pole
captive screw port (see
LAN Ethernet port — If desired, connect the receiver to an Ethernet LAN or WAN
G
via this RJ-45 port. Ethernet control allows the operator to control the receiver from
a remote location. When connected to an Ethernet LAN or WAN, the receiver can be
accessed and operated from a computer running a standard Internet browser (see
Cable Termination and Recommendations
Link (green) LED — Indicates that the unit is properly connected to an Ethernet
•
LAN. This LED should light steadily.
Act (yellow) LED — Indicates transmission of data packets on the RJ-45
•
connector. This LED should blink as the unit communicates.
Analog Audio Connector
figure 2
on page 5) — Connect a serial RS-232
RS-232 and IR Connectors
on page 11 to wire the connector).
FOX3 SR 201 Scaling Receiver • Installation
on page 9 to wire this
HDMI
RS-232 and IR Connectors
figure 3
on page 7),
to wire this connector).
on
TP
6
Advertisement
Table of Contents
