Table of Contents
Advertisement
Analog Audio Connector
See figure 5 to wire the connector for the analog audio. Connectors are included with the
Tip
Sleeve
receiver, but you must supply the audio cable. Use the supplied tie-wraps to strap the cable
Tip
Sleeve
to the extended tail of the connectors.
Unbalanced Stereo Input
No Ground Here
Tip
Sleeves
Tip
No Ground Here
Unbalanced Stereo Output
Figure 5.
ATTENTION:
For unbalanced audio output, connect the sleeves to the ground contact. DO NOT
•
connect the sleeves to the negative (-) contacts.
•
Pour l'audio asymétrique, connectez les manchons au contact au sol. NE PAS
connecter les manchons aux contacts négatifs (–).
NOTE: See the
tinning the wires.
Power Connector
CAUTION: The DC output cables must be kept separate from
each other while the power supply is plugged in. Remove
power before wiring
ATTENTION :
les uns des autres tant que la source d'alimentation est
branchée. Coupez l'alimentation avant d'effectuer les
raccordements.
ATTENTION:
•
Do not connect any external power supplies until you have
read the
Veuillez lire les encadrés «
•
» à partir ci-dessous avant de brancher une source
d'alimentation externe.
1.
Cut the DC output cord to the length needed.
2.
Strip the jacket to expose 3/16 inch (5 mm) of the conductor
wire (see the figure on the right).
3.
Ensure the connections have the correct polarity as shown in the figure above. The wire
with ridges is the ground wire.
4.
Slide the exposed ends of the wire into the captive screw connector and secure by
tightening the screws.
5.
Use the supplied tie wrap to strap the power cord to the extended tail of the connector.
Tip
Ring
Sleeves
Tip
Ring
Balanced Stereo Input
Tip
Ring
Sleeves
Tip
Ring
Balanced Stereo Output
Captive Screw Connector Wiring for Audio Output
Attention
on page 10 regarding the length of the exposed wires and
Les câbles de sortie CC doivent être séparés
Attention
on page 10.
Attention
Do not tin the wires!
on page 10
FOX3 SR 201 Scaling Receiver • Installation
POWER
12V
2.0A MAX
3/16"
(5 mm) Max.
A
A
Ridges
Smooth
SECTION A–A
9
Advertisement
Table of Contents
