Table of Contents
Advertisement
Rear and Side Panel Connectors
Rear
Figure 5.
A
B
B
POWER
12V
0.7A MAX.
XTP R HWP 201
XTP IN
A
Rear Panel Connectors
XTP input connector — Connect a twisted pair cable to the RJ-45 connector labeled
"XTP IN" on the XTP R HWP 201 and the XTP output port on another XTP device to
pass all signals (see
TP Cable Termination and Recommendations
This cable carries the following signals:
Digital video
•
Digital audio
•
Bidirectional RS-232 and IR commands
•
Remote power
•
Ethernet communication
•
System communication
•
Signal LED indicator — Lights green when the receiver is receiving an
active XTP input signal.
Link LED indicator — Lights yellow when XTP devices are connected
and communication is established.
ATTENTION:
•
Do not connect this connector to a computer data or telecommunications
network.
•
Ne connectez pas ce port à des données informatiques ou à un réseau de
télécommunications.
•
XTP remote power is intended for indoor use only. No part of the network that
uses XTP remote power should be routed outdoors (see
page 16).
•
XTP à distance est destiné à une utilisation en intérieur seulement. Aucune
partie du réseau qui utilise l'alimentation XTP à distance ne peut être routée en
Remote Power
extérieur (voir
Power connector — Connect an external power supply to the 2-pole direct insertion
captive screw connector. Confirm the polarity of the power supply wires.
NOTE: The XTP R HWP 201 can also be powered remotely (see
Connection
on page 14).
PWR
SIG
AUDIO
Side
A
à la page 16).
XTP R HWP 201 Wallplate Receiver • Installation
on page 12).
Signal
Link
Remote power
on
Power
8
Advertisement
Table of Contents
