Network Settings Panel; Firmware Panel - Extron electronics FOX3 T 301 User Manual

Network Settings Panel

In the Network Settings panel (see figure 34,
subnet mask, and gateway address for your FOX3, and turn DHCP On and Off.
To set the IP addresses:
1. Click EDIT (see figure 37 [left],
Settings panel opens to allow edits (right).
Figure 37.
2. Edit the network settings as desired:
a. Click the DHCP switch (
the unit configures its IP address and other network settings from the DHCP server.
The default is Off.
b. To set any of the addresses (IP Address (
address (
3.
When finished editing, click out of the field and click SAVE to confirm your changes or
CANCEL to close the window without making changes. Clicking the X in the upper-right
corner of the screen also closes the window.

Firmware Panel

The Firmware panel (see figure 34,
version and the date it was last updated. Update the firmware on the FOX3 T/R 301/311
from this panel (see
firmware files).
To update firmware:
In the Firmware panel, click the SELECT
1.
FILE button.
In the Open dialog box, browse to
2.
locate the new firmware file on your
computer (by default the file is stored
at C:\Program Files (x86)\Extron\
Firmware\FOX3 T/R 301/311 after being
downloaded from the Extron web page).
) in the Network Settings panel. The Network
1
Network Settings Panel
) to toggle DHCP on and off. When DHCP is enabled (On),
2
), click in the desired field and enter the address.
5
, on page 43) displays the current firmware
4
Software/Firmware Installation
FOX3 T/R 301/311 Transmitters and Receivers • Internal Web Page
on page 43), set the IP address,
3
), Subnet mask ( ), and Gateway
3 4
on page 33 to download the
Figure 38. Firmware Panel
45