Table of Contents
Advertisement
Operation
After all transmitters, all receivers, and their connected devices are powered up, the system
is fully operational. If any problems are encountered, verify that the cables are routed and
connected properly. If problems persist, call the Extron S3 Sales & Technical Support
Hotline. See the contact numbers on the last page of this guide for the nearest Extron office.
This section contains information about the local operation of the XTP T HD 4K and
XTP R HD 4K as well as the operational indicators. Topics in this section include the
following:
•
•
•
•
•
•
Transmitter Front Panel Features
Figure 12.
A
B
C
Transmitter Front Panel Features
Receiver Front Panel Features
HDMI Audio Switch
EDID
Audio Output Overview
Reset Modes
A
B
SIGNAL
CONFIG
HDCP
XTP T HD 4K Front Panel Features
Power LED indicator — Lights when the device receives power from the power
supply. This indicator is the same as the Power LED indicator on the rear panel (see
figure
2,
on page 5).
G
Configuration port — Connect a host device to the female USB mini-B port to
configure the connected transmitter or update firmware.
Input LED indicators
Signal — Lights when an active video signal is detected from the source.
•
HDMI Audio — Lights when the HDMI audio input is selected.
•
HDCP — Lights when the input signal is encrypted.
•
Analog Audio — Lights when the analog audio input is selected.
•
Audio Signal Clip — Lights while the analog audio input signal remains above
•
-3 dBFS. The LED remains lit for 200 milliseconds after the signal falls below
-3 dBFS.
XTP T HD 4K Transmitter and XTP R HD 4K Receiver • Operation
C
INPUT
HDMI AUDIO
AUDIO SIGNAL CLIP
ANALOG AUDIO
XTP T HD 4K
16
Advertisement
Table of Contents
