Table of Contents
Advertisement
Installation and
Operation
This section describes the installation and the operation of the DTP DVI 330 Tx/Rx Extender,
including:
•
•
•
Mounting the Units
Mounting instructions can be found in
page 10. Compatible optional hardware is listed on the www.extron.com.
Connections
Transmitter Connections
DDC ROUTE
POWER
REMOTE
12V
0.8 A MAX
ON
1 2
SPARE
LOCAL
Rear
6
Figure 2.
1
2
Mounting the Units
Connections
Operation
OVER DTP
SIG
LINK
RS-232
IR
DTP OUT
Tx
Rx
G
Tx
Rx
5
4
DTP DVI 330 Tx Connectors
DVI input connector — Connect an DVI cable between this port and the DVI output
port (or HDMI port, with an appropriate adapter) of the digital video source.
Local Output connector — If desired, connect a DVI monitor for local monitoring of
the input digital image.
NOTES:
•
The local output is limited to a data rate of 4.95 Gbps (1.65 Gbps per color).
•
In a system where the local output is not used, ensure that you power up the
end display first before the video source. Route the DDC to the remote end
(see the
DDC Route switch
DTP DVI 4K 330 Transmitter and Receiver • Installation and Operation
Mounting the Transmitter or Receiver
INPUTS
DVI-D
AUDIO
Front
3
1
[see
on page 9]).
3
on
LOCAL OUTPUT
DTP DVI 330 Tx
2
3
Advertisement
Table of Contents
