Installation And Operation; Mounting The Transmitter Or Receiver; Ul And Safety Guidelines; Preparing The Site And Installing The Wall Box - Extron electronics DTP DVI 4K 230 D Series User Manual

Installation and
Operation
This section describes the installation and the operation of the DTP DVI 4K 230 D
transmitter and receiver, including:
•
•
•
•
•
•
•
•

Mounting the Transmitter or Receiver

ATTENTION:
The DTP DVI 4K 230 D transmitter and receiver can be installed in a two-gang electrical wall
box or with a mud ring, with a decorator-style wallplate cover (supplied).
The installation must conform to national and local electrical codes and to the size
requirements of the wall plate.

UL and Safety Guidelines

The following UL guidelines pertain to the installation of the decorator-style wallplate
transmitters and receivers into a wall or furniture.
•
•
•

Preparing the Site and Installing the Wall Box

Choose a location that allows cable runs without interference. Allow enough depth for
both the wall box and the cables. The box should be at least 3.0 inches (7.6 cm) deep
to accommodate the connectors and cables. Install the cables into the wall, furniture, or
conduits before installing the wall plate.
Mounting the Transmitter or Receiver
Transmitter Connections
Receiver Connections
Connector and Cable Details
Power Supply Wiring
RS-232 and IR Connector Wiring
Operation
Ground Loops
• Installation and service must be performed by experienced personnel.
• L'installation et l'entretien doivent être effectués par du personnel expérimenté.
These units are not to be connected to a centralized DC power source or used beyond
their rated voltage range.
These units must be installed in UL-listed junction boxes.
These units must be installed with conduit in accordance with National Electrical Code.
DTP DVI 4K 230 D Transmitter and Receiver • Installation and Operation 3