Analog Audio Connectors; Rs-232, Ir, And Sync Connectors - Extron electronics FOX3 T 301 User Manual

Analog Audio Connectors

See figure 7 to wire connectors for the appropriate input and output type for the analog
audio and audio return audio. Connectors are included with the transmitter and receiver,
but you must supply the audio cable. Use the supplied tie-wraps to strap the cable to the
extended tail of the connectors.
Tip
Sleeve
Tip
Sleeve
Unbalanced Stereo Input
No Ground Here
Tip
Sleeves
Tip
No Ground Here
Unbalanced Stereo Output
Figure 7.
ATTENTION:
• For unbalanced audio output, connect the sleeves to the ground contact. DO NOT
connect the sleeves to the negative (-) contacts.
Pour l'audio asymétrique, connectez les manchons au contact au sol. NE PAS
•
connecter les manchons aux contacts négatifs (–).
NOTES:
• The length of exposed wires is important. The ideal length is 3/16 inch (5 mm).
• If the stripped section of wire is longer than 3/16 inch, the exposed wires may
touch, causing a short circuit.
• If the stripped section of wire is shorter than 3/16 inch, wires can be easily pulled
out even if tightly fastened by the captive screws.
Do not tin the wires before installing them in the connector. Tinned wires are not as
•
secure in the connector and could be pulled out.

RS-232, IR, and Sync Connectors

Figure 8 shows how to wire the Control (RS-232 and IR) and Remote (RS-232 and 3D Sync)
connector.
CONTROL
Figure 8.
NOTES:
• The IR Tx and Rx line pair and the RS-232 Tx and Rx line pair must each cross
once between this connector and the source or destination.
The length and preparation of exposed wires is important (see the audio connector
•
NOTES above for details).
Tip
Ring
Sleeves
Tip
Ring
Balanced Stereo Input
Tip
Ring
Sleeves
Tip
Ring
Balanced Stereo Output
Captive Screw Connector Wiring for Audio Inputs and Outputs
IR Device
Rx Tx Gnd
Tx Rx Gnd
RS-232 Device
Control and Sync Connectors Wiring
FOX3 T/R 301/311 Transmitters and Receivers • Installation and Operation
Do not tin the wires!
14