NOTES:
•
If you have removed the ground jumpers (see
ground potential differences, the DTP HDMI 4K 230 cannot extend analog audio. No analog audio
is output.
•
The length of exposed wires is critical. The ideal length is 3/16 inch (5 mm).
•
If the stripped section of wire is longer than 3/16 inch, the exposed wires may touch, causing a short
circuit.
•
If the stripped section of wire is shorter than 3/16 inch, wires can be easily pulled out even if tightly
fastened by the captive screws.
•
Do not tin the power supply leads before installing them in the connector. Tinned wires are not as
secure in the connector and could be pulled out.
RS-232 and IR connector — Connect a serial RS-232 signal, a modulated IR signal, or both
9
to this 3.5 mm, 5-pole captive screw connector for bidirectional RS-232 and IR communication
(see
RS-232 and IR connector wiring
Power input connector — Plug the included external 12 VDC power supply into either this 2-pole
¢
connector or the power input connector on the transmitter (see
page 8 to wire the connector).
NOTES:
•
One power supply is included with the transmitter and normally can power both units.
•
If you have removed the ground jumpers (see
of ground potential differences, one DTP HDMI 4K 230 unit cannot remotely power the other unit.
Each unit requires a local power supply.
Connector and Cable Details
TP cable termination and recommendations
Figure 5 details the TIA/EIA T 568B wiring standard. Use this standard
to terminate TP cables with RJ-45 connectors.
NOTE: Do not use Extron UTP23SF-4 Enhanced Skew-Free AV
UTP cable or STP201 cable to link the transmitter and receiver.
The DTP HDMI 4K 230 Tx/Rx does not work properly with these
cables.
Supported cables —
The DTP HDMI 4K 230 is compatible with CAT 5e, 6, 6a, and 7 shielded
twisted pair (F/UTP, SF/UTP, and S/FTP) and unshielded twisted pair
(U/UTP) cable.
on page 9 to wire the connector).
DTP HDMI 4K 230 Tx/Rx Transmitter and Receiver • Installation and Operation
Disconnecting the Ground
on page 5) (see
5
Disconnecting the Ground
Side
Figure 5.
on page 13) because of
Power supply wiring
on
on page 13) because
Pins:
RJ-45
1 2 3 4 5 6 7 8
Connector
TIA/EIA T
568 B
Pin
Wire color
1
White-orange
Orange
2
3
White-green
4
Blue
5
White-blue
6
Green
Insert
7
White-brown
Twisted
8
Brown
Pair Wires
TP Cable Termination
7