Description Of The Error Message System; Procedure While Error 14 - Hermle Z 207 MK User Manual

TROUBLE SHOOTING

4.2.2 Description of the Error Message System

The error message, "error" (M11), is shown in the "time" (A-3) display, (see Figure 31). For more
detailed information, refer to Table 6: "Error Messages", (see Appendix P.VI).
Figure 31

4.2.3 Procedure while error 14

If Error 14 occurs, there is a problem with the speed sensor. The centrifuge lid is closed for
undefined period of time and in the "rpm/rcf" (A-1) display shows the lettering "USEr GuidE" (see
Figure 32).
Figure 32
To reopen the centrifuge lid, switch off the device and wait until the rotor has come to a standstill.
Take from "Table 5: Acceleration and Deceleration Times" the maximum deceleration time of the
respective rotor. Level 0 corresponds to unbreaked rundown, which occurs at error 14. If the
centrifuge lid is opened before standstill of the rotor, a following error can occur.
Once the rotor has come to a standstill, open the centrifuge lid with the emergency release. Proceed
as described in chapter 4.2.1, p 26. After opening the centrifuge lid, switch on the device again.
Error 14 and the lettering "USEr GuidE" should be eliminated.
If these errors occur again, please contact the service.
28
Z207MK_V1.21_eng © Hermle Labortechnik GmbH