Recall Of Stored Programs - Hermle Z 207 MK User Manual

OPERATION
Close the lid of the centrifuge, now proceed as described above, to set all important run parameters.
If the lid isn´t closed, when storing the program in the display "rpm/rcf" (A-1), flashes alternately the
word "FirSt" and "CLOSE Lid" (see Figure 26). When starting the run without storing the program, in
the display "rpm/rcf" (A-1), flashes alternately the word ""First" and "PrESS StoreE", (see Figure 27).
Figure 24
Figure 25
For alteration of data, press the key "store" (12), for approx. 1 second. If the program is stored
correctly, the word "StorE" appears in the display "rpm/rcf" (A-1). As a result, the word "program"
(M10) disappears. As soon as the key "store" (12) is no longer displayed, the word "programm xx"
(M10) reappears. ( the xx stands for the chosen program place).
If all program numbers are occupied, take an old number that is not needed any longer and replace
it with the new parameters.
For all number marked text, please refer to Figure 24 and Figure 25.

2.5.2 Recall of Stored Programs

To recall stored programs, press the key "prog" (11), with the lid already closed. Inside the display
"time" (A-3), appears "programm --"(M10). With the control field (1), pre-select the desired program
number.
In the respective displays, the stored values, for that program, will appear.
If there is not the correct rotor inside the centrifuge, for the pre-selected program, in the display
"rpm/rcf" (A-1) flashes the word "rotor" (M3). At the same time, the word "FALSE" and the stored
rotor number "22x. xx""(M4) flash in sequence of one another.
For all number marked text, please refer to Figure 26.
Figure 26
20
Z207MK_V1.21_eng © Hermle Labortechnik GmbH