Epilog Laser Fusion Pro 32 Manual
Hide thumbs
Also See for Fusion Pro 32:
- Assembly replacement (22 pages) ,
- Manual (9 pages) ,
- Original instructions manual (242 pages)
Advertisement
Quick Links
Carriage Camera Replacement
Parts Required
•
LC0240 - Assy, Camera, X-Axis
!
An anti-static strap is required when working with any PCB in the Fusion Pro
engraver. This strap prevents the buildup and accidental discharge of static
electricity which can damage sensitive electronic components.
Fusion Pro 24 & 36
•
5/32" Allen wrench
•
Phillips head screwdriver
01/2023
www.epiloglaser.com
tech@epiloglaser.com
303-215-9171
Tools Required
.
Advertisement
Related Manuals for Epilog Laser Fusion Pro 32
Summary of Contents for Epilog Laser Fusion Pro 32
- Page 1 www.epiloglaser.com tech@epiloglaser.com 303-215-9171 Carriage Camera Replacement Fusion Pro 24 & 36 Parts Required Tools Required • LC0240 - Assy, Camera, X-Axis • 5/32” Allen wrench • Phillips head screwdriver An anti-static strap is required when working with any PCB in the Fusion Pro engraver.
- Page 2 17000 Carriage Camera Replacement Using the Anti-Static Clamp Open Strap An anti-static strap is required when working with any PCB in the Fusion Pro engraver. This strap prevents the buildup and accidental discharge of static electricity which can damage sensitive electronic components.
- Page 3 17000 Carriage Camera Replacement Carriage Camera 6. The preferred location to attach the alligator clip is the chassis bolt that Replacement connects to the ground from the regenerative clamp, located behind the right panel of the engraver: Carriage Camera Removal 1.
- Page 4 17000 Carriage Camera Replacement 7. Disconnect the air assist tubing from 5. Manually move the x-axis assembly to the middle of the engraver: the camera bridge: 8. Disconnect the electrical harness from the carriage camera PCB: 6. Disconnect the autofocus switch electrical harness: BACK SIDE OF X-AXIS ASSEMBLY 9.
- Page 5 17000 Carriage Camera Replacement 10. Loosen and remove the two (2) Phillips 13. Hold the carriage camera housing to screws that secure the camera bridge ensure it does not fall and become to the carriage assembly: damaged. Loosen and remove the three (3) Phillips screws that secure the carriage camera board housing to the camera bridge:...
- Page 6 17000 Carriage Camera Replacement 15. Remove the carriage camera board 2. Place the carriage camera board in from the carriage camera housing: the carriage camera housing: 3. Install and tighten the seven (7) Phillips Carriage Camera Installation screws that secure the carriage camera board to the carriage camera housing: 1.
- Page 7 17000 Carriage Camera Replacement 4. Place the carriage camera housing in 7. Install and tighten the two (2) Phillips the camera bridge. Install and tighten screws that secure the cable track to the three (3) Phillips screws that secure the carriage assembly: 8.
- Page 8 17000 Carriage Camera Replacement Programming the Lens Camera 4. Once in the Advanced Settings menu, enter the Diagnostics menu and use Board the arrow keys to scroll to the Camera tab: 1. Reconnect to power and turn on the engraver. 2.