Starting The Engine - HERO SPLENDOR iSMART PROGRAMMED FI Manual

Fitting & Fasteners-Check & tighten if
•
necessary.
Steering-Check for smooth action for
•
easy maneuverability.
Side stand indicator-Make sure that the
•
side stand is up. If it is in down position the
side stand indicator (page19) will glow on
the speedometer panel.

STARTING THE ENGINE

Always follow the proper starting procedure
described below :
To protect the catalytic converter in your
•
vehicle's exhaust system, avoid extended
idling and the use of leaded petrol.
Your vehicle's exhaust contains poisonous
•
carbon monoxide gas. High levels of carbon
monoxide can collect rapidly in enclosed
areas such as garage. Do not run the engine
with the garage door closed.
CAUTION
! !
If electric starter switch is pressed
•
continuously and engine does not start,
cranking of engine will stop after 5 secs.
After that rider again needs to press the
electric starter switch.
If engine started, cranking of the engine will
•
stop after r/min reaches more than 850.
Preparation
Before starting insert the key and follow the
below mentioned procedure :
Turn the ignition switch (1) to "ON" ( )
•
position.
Confirm that the programmed FI
•
malfunction indicator lamp (MIL) (2)
glows continuously and then should go
"OFF" once the engine is started.
1
(1) Ignition switch
malfunction indicator lamp (MIL)
If MIL remains "ON" even if the vehicle is
started, there is an abnormality in the
programmed FI system. It is recommended to
reduce the speed and drive to the Authorised
workshop for check-up
Hero MotoCorp
Find neutral position & check neutral
Ÿ
N indicator (3) on instrument console
with ignition "ON".
23
2
(2) Programmed FI
NOTE