Mortise Lock Door Preparation & Installation - Assa Abloy Corbin Russwin ML2000 Series Installation Instructions Manual

BHSS Trim
ML2000 Series Mortise Lock
Installation Instructions
2 Mortise Lock Door Preparation & Installation
Important: Be sure to hand the lockbody
before installing. See page 4.
1. Insert mortise lock into door and fully
tighten 1" lock mounting combination
screws. (Figure 6)
2. Insert spindle into outside lockbody hub.
3. Slide trim door marker template over
Lock-body
spindle.
Installation
NOTE:
MAKE SURE TEMPLATE IS ORIENTED
CORRECTLY . (FIGURE 7)
4. Square template to edge of door. (Figure 7)
5. Mark two thru-bolt holes.
6. Repeat steps 2-5 for inside of door.
7. TURN-PIECE FUNCTIONS ONLY:
Insert turn-piece door marker spindle into
lockbody on inside of door.
NOTE:
USE SQUARE SIDE OF DOOR MARKER SPINDLE .
(FIGURE 8)
8. TURN-PIECE FUNCTIONS ONLY:
Slide turn-piece door marker over spindle.
9. TURN-PIECE FUNCTIONS ONLY:
Mark three holes for turn-piece. (Figure 9)
10. COIN-TURN FUNCTIONS ONLY:
Insert turn-piece marker spindle into lockbody
on outside of door.
NOTE:
USE SQUARE SIDE OF DOOR MARKER SPINDLE .
(FIGURE 8)
11. COIN-TURN FUNCTIONS ONLY:
Slide turn-piece door marker template over
spindle.
12. COIN-TURN FUNCTIONS ONLY:
Mark two holes for coin-turn. (Figure 10)
For installation assistance contact Corbin Russwin
1-888-607-5703 • support@corbinrusswin.com
Copyright © 2017 Corbin Russwin, Inc., an ASSA ABLOY Group company.
All rights reserved. Reproduction in whole or in part without the express written
permission of Corbin Russwin, Inc. is prohibited.
Square
Side
Turn-Piece Door
Marker Template
Figure 9
3
Figure 6
Figure 7
Figure 8
Inside
of Door
Turn-Piece Door
Marker Template
Outside
Figure 10
of Door
FM352 10/18