Assa Abloy SARGENT FM7300 Series Installation Instructions Manual page 11

Multi-Point Lock
FM7300 Series and BL7300 Series
Installation Instructions
3 Installation (cont.)
h Top and Bottom Latch Adjustment (cont.)
Using the supplied 3/32" Allen wrench, rotate the top
or bottom worm gears according to the directions
below (Figure 19). Bolt to strike clearance should
equal 1/16". This sets the bolt projection. (Figure 20)
Note:
Ten (10) turns equals approximately 1/16".
Rotate the top:
counterclockwise
project the bolt;
clockwise
the bolt.
Rotate the bottom:
counterclockwise
retract the bolt;
clockwise
the bolt.
Note:
Latches have bottomed
if worm gears click.
Tighten set screws. (Figure 21)
1-800-727-5477 • www.sargentlock.com
Copyright © 2020 SARGENT Manufacturing Company. All rights reserved. Reproduction in whole or in
part without the express written permission of SARGENT Manufacturing Company is prohibited.
to
to retract
to
to project
Figure 21
TOP OF DOOR
BOTTOM OF DOOR
Figure 19
Worm Gear
Worm Gear
Figure 20
IMPORTANT
Set screws must be fully
tightened after adjustment.
11
1/16" Bolt to strike clearance.
1/16" Bolt to strike clearance.
A8220D 04/20