Mortise Lock Handing Instructions - Assa Abloy Corbin Russwin ML2000 Series Installation Instructions Manual

M, N and P Escutcheon Trim
ML2000 Series Mortise Lock
Installation Instructions
1

Mortise Lock Handing Instructions

1. Move red locking screw to side of lockbody
being locked.
2. Push in latch. Depress catch plate with
screwdriver. (Figure 1)
3. Pull latch out of lock-body and turn latch
over. (Figure 2)
4. Push in latch while holding
screwdriver behind latch tail.
(Figure 8)
NOTE:
Push in latch until catch plate is
no longer depressed. (Figure 4)
5. Rotate lock front to match bevel of door,
as shown. (Figure 10)
For installation assistance contact Corbin Russwin
1-800-543-3658 • techsupport.corbinrusswin@assaabloy.com
Corbin Russwin is a brand associated with ASSA ABLOY Access and Egress Hardware Group, Inc., an ASSA ABLOY Group company.
Copyright © 2018, ASSA ABLOY Access and Egress Hardware Group, Inc. All rights reserved. Reproduction in whole or in part without
the express written permission of ASSA ABLOY Access and Egress Hardware Group, Inc. is prohibited.
LOCK HANDING
IS CRITICAL TO
ENSURE LOCK
FUNCTIONS
PROPERLY
RED Locking Screw
MAKE SURE CATCH PLATE IS
EVEN W/ TOP SURFACE
GOOD BAD
Figure 4
Figure 3
2
Catch Plate
Figure 1
Figure 2
WARNING:
LOCK-IN CAN
OCCUR IF LATCH
IS NOT PROPERLY
INSTALLED
Figure 5
FM483 11/18