Prepare Lock For Installation - Assa Abloy Yale Real Living YRD210-ZW Installation And Programming Instructions

Unpack the Lock
The lock is packed representative of how it will install on
the door.
Before installing the lock on the door:
A. Inside escutcheon
1. Loosen the screw (Phillips #2) holding the battery
cover. (The screw remains attached to battery
cover)
2. Slide the battery cover up and out (note the two tabs
at bottom of battery cover).
3. Remove the inside mounting plate (with gasket) from
the back (door side) of the inside escutcheon.
Inside Escutcheon & Mounting Plate
(with gasket)
3
B. Bolt
Note: Bolt ships with backset in 2-3/8" posi-
tion. If required, press small black button on
underside of bolt and pull to extend to 2-3/4"
backset position.
C. The outside escutcheon (with gasket) remains assembled.
An ASSA ABLOY Group brand

PREPARE LOCK FOR INSTALLATION

a. Ensure that gasket
on Inside Mounting
Plate is properly
fitted. Note the
positioning of the
gasket's five rubber
nubs (Figure 3A) .
Inside Escutcheon
1
Figure 3A
Figure 3B
Outside Escutcheon
Battery Cover
2
Detail 3B1
6
P/N AYRD210-INST-FUL Rev B