Mortise Lock Door Preparation & Installation - Assa Abloy Sargent 8200 Installation Instructions Manual

BHL Trim
8200 Mortise Lock
Installation Instructions
3 Mortise Lock Door Preparation & Installation
Important: Be sure to hand the lockbody
before installing. See Section 1.
1. Insert mortise lock into door and fully
tighten 1" lock mounting combination
screws. (Figure 2)
2. TURN-PIECE FUNCTIONS ONLY:
Insert turn-piece door marker spindle into
lockbody on inside of door.
NOTE:
USE BLADE SIDE OF DOOR MARKER SPINDLE .
(FIGURE 3)
3. TURN-PIECE FUNCTIONS ONLY:
Slide turn-piece door marker over spindle.
4. TURN-PIECE FUNCTIONS ONLY:
Mark three holes for turn-piece. (Figure 4)
5. COIN-TURN FUNCTIONS ONLY:
Insert turn-piece marker spindle into
lockbody on outside of door.
NOTE:
USE BLADE SIDE OF DOOR MARKER SPINDLE .
(FIGURE 3)
6. COIN-TURN FUNCTIONS ONLY:
Slide turn-piece door marker template over
spindle.
7. COIN-TURN FUNCTIONS ONLY:
Mark two holes for coin-turn. (Figure 5)
1-800-727-5477 • www.sargentlock.com
Copyright © 2017, Sargent Manufacturing Company, an ASSA ABLOY Group
company. All rights reserved. Reproduction in whole or in part without the express
written permission of Sargent Manufacturing Company is prohibited.
Turn-Piece Door
Marker Template
Figure 4
Turn-Piece Door
Marker Template
4
Figure 2
Blade
Side
Figure 3
Inside
of Door
Outside
of Door
A8131E 11/17
Figure 5