Setting Up A Projector For The Upx-2 - Crestron UPX-2 Operation Manual

Universal Presentation Processor

Setting Up a Projector for the UPX-2

Operations Guide – DOC. 6276B
The following procedure describes how to configure the audience output for use with
a projector.
1. Set the projector's aspect ratio (4:3 or 16:9) and turn off the keystone
feature.
2. Open the SETUP MENU as described in "Configuring the UPX-2" on page
23 and press the Display Output button to configure the UPX-2's display
output.
3. Set the resolution to the projector's native resolution.
4. Select the "Grid" test pattern on the UPX-2 and adjust the vertical &
horizontal position on the projector. Do not adjust the size if the UPX-2 is
set to the projector's native resolution.
5. Select the "Vertical Lines" test pattern on the UPX-2 and adjust the
projector as required.
a. If vertical bars are displayed, adjust the Coarse adjustment (also
known as "Clock Adjustment", "Pixel/Dot clock", and "Pitch
Adjustment") to eliminate the vertical bars.
b. If the image has horizontal noise, adjust the Fine adjustment (also
known as "Phase Adjustment") to eliminate the problem.
c. Select the Grid test pattern and recheck the position.
6. Close the Display Output window by pressing Close.
7. Adjust the projector for RGB sources connected to the UPX-2.
a. Install Crestron Toolbox on the RGB source.
b. Open Crestron Toolbox and select the Video Test Pattern tool by
clicking the
c. Select the Grid test pattern from the drop-down menu and click the
Full Screen button.
d. From the UPX-2 SETUP MENU, open the "RGB/Video Setup"
window and select the RGB source.
e. Adjust the position of the RGB source. If the source is not native
resolution to the UPX-2 output, adjust the size as necessary. If the
source is native resolution to the UPX output, do not adjust size;
this will reduce the image quality of the source.
f. On the RGB source, click the Grid test pattern, select the Vertical
Bars test pattern from the drop-down menu, and click the Full
Screen button.
g. On the UPX-2, adjust the Coarse or Fine settings. If noisy, adjust
the Fine setting. If there are vertical bars, adjust the Coarse
setting.
h. On the RGB source, click the Vertical Bars test pattern, select the
Color Bars test pattern from the drop-down menu, and click the
Full Screen button.
i. On the UPX-2, adjust the Color settings.
8. Repeat for every RGB source that is connected to the UPX-2.
button.
Universal Presentation Processor: UPX-2 ¥ 57
Crestron UPX-2