Industry Compliance - Crestron UPX-2 Operation Manual

Crestron UPX-2
18 ¥ Universal Presentation Processor: UPX-2
PWR
A front panel Power LED indicates when power is applied to the UPX-2 via the AC
power cord connection. Press and hold the momentary power on/off button for five
seconds to shut down the system (overrides the main off switch on the rear). Press
momentarily to restart.
NET
The NET LED flashes to indicate network activity.
RESET
The system-reset button provides a full hardware and software reset.
SETUP LED and Pushbutton
The UPX-2 is Touch-Settable ID-ready. A SETUP pushbutton and associated LED
are located on the rear of the unit next to the Cresnet connector. The SETUP
pushbutton and its associated LED are used for setting a unit's network ID during
the initial configuration of a Cresnet system or when the device is being
added/replaced. Refer to "Identity Code" on page 21 for more information.

Industry Compliance

This product is Listed to applicable UL Standards and requirements by Underwriters
Laboratories Inc.
As of the date of manufacture, the UPX-2 has been tested and found to comply with
specifications for CE marking and standards per EMC and Radiocommunications
Compliance Labelling.
NOTE: This device complies with part 15 of the FCC rules. Operation is subject to
the following two conditions: (1) this device may not cause harmful interference, and
(2) this device must accept any interference received, including interference that may
cause undesired operation.
Universal Presentation Processor
(E174344)
Operations Guide – DOC. 6276B