Crestron UPX-2 Operation Manual page 48

Crestron UPX-2 Universal Presentation Processor
UPX-2 SETUP MENU
NOTE: For output displays set to resolutions greater than 800 x 600, the SETUP
MENU may be displayed on the left side of the screen. If this occurs, the display
needs to be adjusted. To adjust the display, select Display Output from the SETUP
MENU and select the Full Screen White test pattern. Turn off the display's power
and turn back on after five seconds. Press the screen to return to Display Output
dialog and then press Close to return to the SETUP MENU. The display will be
adjusted and the SETUP MENU will be centered on the display.
The SETUP MENU provides access to all basic functions and parameters. It is
divided into SETUP, ETHERNET, STANDBY TIMEOUT, MISC. CONTROLS and
SHUTDOWN sections.
NOTE: To allow the UPX-2 to upload projects, Standby Timeout is disabled until
approximately five minutes after the project is loaded.
To exit the SETUP MENU and return to the program, press Exit, located at the
bottom of the SETUP MENU. To reboot the UPX-2, press Save & Reboot, located
in the SHUTDOWN section of the SETUP MENU.
CAUTION: At power up or reboot, the touchpanel will cycle through colors and the
Crestron logo screen for approximately 2.5 minutes prior to displaying the progress
bar. This is a normal part of the boot up process. Do not turn off power to the UPX-2
while is rebooting. Damage may occur.
26 ¥ Universal Presentation Processor: UPX-2 Operations Guide – DOC. 6276B