Crestron UPX-2 Operation Manual page 88

Crestron UPX-2
66 ¥ Universal Presentation Processor: UPX-2
8. Click the System Info icon
the drop-down list on the bottom of the page, select the entry created in
step 7.
If the UPX-2 is to communicate with a control system over TCP/IP, an IP table must
be created on the UPX-2 to identify the control system(s) it will communicate with
over TCP/IP.
Use the following instructions to create the IP table.
1. Select Functions | IP Table Setup from the Crestron Toolbox menu bar.
"IP Table" Window
2. If the UPX-2 already has an IP table, it is displayed at the top of the
window.
3. Click Add Entry to add a new IP table entry or select an existing IP entry
from the list and click Modify Entry. Up to 252 entries can be listed on a
UPX-2's IP table. Click Remove [Del] to remove a selected IP entry or
click Clear List to remove all of the entries from the IP table.
NOTE: IP table entries that have not yet been sent to the device are listed in
red.
If loading a saved IP table, click Load From File... to browse for a saved
IP table.
Universal Presentation Processor
to display the "System Info" window. From
Operations Guide – DOC. 6276B