Selecting Signals; Edit Signal Name - Crestron SW-SIMPL Installation & Operating Manual

Crestron SIMPL™ Windows
Installation & Operations Guide – DOC. 5728C
Enter Signal Name – Program View
4. Press Enter on your keyboard
The signal is created! Notice that after a signal is created, it appears in the Signal List
folder at the bottom of the Program Tree, in Program View.

Selecting Signals

Signal selection in SIMPL Windows follows two standard Windows conventions:
the SHIFT key is used to select a bloc of signals directly above or below each other
in an input or output column. The CONTROL key is used to select two or more
signals present in the same input or output column or in the same symbol, but not
necessarily directly above or below each other.
Select One Signal in Detail View
1. At least one symbol must present in Detail View, in order to select a
signal.
2. Click the desired signal once with your mouse to select it.
Select Multiple Signals in Detail View
1. Click the first signal in the bloc of signals to be selected
2. Press and hold the SHIFT key
3. Click the last signal in the bloc of signals to be selected
The entire bloc will be highlighted.
•
SHIFT-END will select downward, from the signal your cursor is on, to the last
signal.
•
SHIFT-HOME will select upward, from the signal your cursor is on, to the first
signal.

Edit Signal Name

In Detail View
1. Double-click on an existing signal. A blinking cursor will appear.
2. Make the signal name modifications.
3. Press Enter on your keyboard.
Software
Crestron SIMPL Windows • 75