Notice (Cmcvt141); Notice (Cmcvt142); Notice (Cmcvt143); Failure (Cmcvt144) - Crestron SW-SIMPL Installation & Operating Manual

Crestron SIMPL™ Windows
Installation & Operations Guide – DOC. 5728C

NOTICE (CMCVT141)

Symbol S-1 is not supported, ignoring.
The GENERIC symbol is no longer supported since support for the DOS compiler
was removed. If you have a GENERIC symbol in your program that you wrote in an
older version of SIMPL Windows (1.18.01 and below), remove the GENERIC and
add the symbol to your program from the Symbol Library.

NOTICE (CMCVT142)

Symbol S-2 in Macro S-5 (Macro file
C:\CRESTRON\SIMPL\USRMACRO\MYMACRO.UMC) is not supported,
ignoring.
The GENERIC symbol is no longer supported since support for the DOS compiler
was removed. If you have a GENERIC symbol in a macro that you wrote in an older
version of SIMPL Windows (1.18.01 and below), remove the GENERIC and add the
symbol to your program from the Symbol Library.

NOTICE (CMCVT143)

Invalid Chain list "03,04" for ID-03 Touchpanel, ignoring.
This error is a result a difference in how chaining works between different versions
of SIMPL Windows. Please contact Crestron for assistance.

FAILURE (CMCVT144)

Could not invoke SIMPL+ Compiler for c:\crestron\usrsplus\myfile.usp.
There was an error invoking the SIMPL+ compiler. This can happen when the
compiler cannot open or read the specified SIMPL+ module (i.e., if the USP file does
not exist on disk or the file is zero length). Check to make sure the path to the User
SIMPL+ modules is correct and that the module actually exists in the directory
specified.

WARNING (CMCVT145)

Could not extract Crestron SIMPL+ file c:\crestron\cresspls\cresspls.csp,
ignoring.
Crestron supplied SIMPL+ modules are stored in an archived format to keep disk
space at a minimum and are only extracted when they need to be processed by the
compiler. If this error appears, check to make sure the CRESSPLS.CSZ file exists in
your SIMPL Windows directory.

NOTICE (CMCVT146)

Error adding c:\crestron\usrsplus\myfile.uf to SIMPL+ Transfer File.
SIMPL+ programs are stored in an archived format for transfer to the control system.
This error indicates that the system was unable to add the SIMPL+ program to the
archive for transfer.
Software
Crestron SIMPL Windows • 193