Viewport: File Menu; Viewport: Edit Menu; Viewport: Setup Menu - Crestron SW-SIMPL Installation & Operating Manual

Crestron SIMPL™ Windows

Viewport: File Menu

Viewport: Edit Menu

Viewport: Setup Menu

Installation & Operations Guide – DOC. 5728C
Save Current Buffer
The Save Current Buffer command saves incoming data to an ASCII text file (the
Viewport buffer holds roughly 10K of data). Browse to the desired directory, enter a
name for the file (it will have a .cap extension) and click Save.
Log Incoming Data to File
The Log Incoming Data to File command writes incoming data to an ASCII .log
file. To begin logging, click Start, browse to the desired directory, enter a name for
the file and click Save. As data comes into the Viewport console it will be written to
the file, together with a Time Stamp that gives the date and time (to the nearest
second) that the data was received.
To halt the logging operation, click Stop or Pause.
Exit
The Exit command closes Viewport.
Copy
The Copy command copies the selected text to the Clipboard.
Paste
The Paste command writes the contents of the Clipboard to the Viewport screen and
transmits the pasted characters using the selected connection (as if they were typed
in).
Clear Data
The Clear Data command clears the Viewport buffer and all displayed text.
Use the Setup menu to set preferences for the display of characters in the Viewport
Incoming and Outgoing Data panes, and to specify communications and port
settings.
Auto Baud Search
Viewport attempts to establish communication at the baud rate specified in Setup |
Communication Settings. However, if the control system is not detected and Auto
Baud Search is enabled, Viewport will cycle through all possible baud rates
(beginning at 115200 and working back to 300) until it finds the control system. If
communication still cannot be established, an error message will be displayed.
Software
Crestron SIMPL Windows • 103