Failure (Cmcvt118); Warning (Cmcvt119); Warning (Cmcvt120); Failure (Cmcvt121) - Crestron SW-SIMPL Installation & Operating Manual

Crestron SIMPL™ Windows
Installation & Operations Guide – DOC. 5728C

FAILURE (CMCVT118)

Unable to allocate Initialization Memory
In practice this error is rare, and is issued if the compiler cannot allocate initialization
memory.

WARNING (CMCVT119)

No rack was defined, assuming CNRACK.
The rack type must be specified so that the output binary file may be written in the
proper format. If no rack is specified, the compiler assumes a particular rack model.

WARNING (CMCVT120)

Function PLAY referenced by driver
C:\CRESTRON\USERDB\MYDRIVER.IR in CNIR-8 Slot 5 Port A does not
exist, skipping.
This error is rare, and only happens if a function is specified through SIMPL
Windows that does not exist in the driver file. Since SIMPL Windows finds the
function names in the IR file, the only way this can happen is if the IR driver is
edited and a function is changed after putting that driver on a port.

FAILURE (CMCVT121)

Error allocating memory for Macro C:\MYMACROS\FLY-LOGO.UMC.
This error results from the system not being able to allocate memory to load in a
macro for processing.

FAILURE (CMCVT122)

Error loading Macro C:\MYMACROS\FLY-LOGO.UMC.
This can happen if the file specified does not contain a valid macro file or the system
was unable to read the file off of disk.

FAILURE (CMCVT123)

Internal memory allocation error processing Macro C:\MYMACROS\FLY-
LOGO.UMC.
This error results from the system not being able to allocate memory to load in a
macro for processing.

WARNING (CMCVT124)

Undefined input INPUT-1 on Macro C:\MYMACROS\FLY-LOGO.UMC,
defaulting to 0.
A macro must have all inputs and outputs filled. If one of the inputs is left without a
signal name, the compiler will hold it at a logic low level.
Software
Crestron SIMPL Windows • 189