File Transfer - Crestron SW-SIMPL Installation & Operating Manual

Software
170 • Crestron SIMPL Windows

File Transfer

Send Program
Send Touchpanel
Send File to Mailbox...
Get File from Mailbox...
Load NVRAM from file...
Save NVRAM to file...
Update Control System...
Update Operating
Update Monitor ROM...
Update Touchpanel
Firmware...
Load Network Device...
Update Plug-in Card...
General File Transfer >
This grouping of commands is used to transfer or receive files from a non-
Crestron system. These are generic file transfer commands, that would be
used with any terminal program. They pertain to data coming and going from
the ViewPort to the serial port on your PC.
Choose File...
ASCII Upload...
ASCII Download...
XModem Upload...
XModem Download...
XModem 1K Upload...
XModem 1K Download...
Send SIMPL+ Program to
the CEN-OEM
Crestron SIMPL™ Windows
Alt+P Transfers Program to the Control System
Alt+T Sends Touchpanel (.hex file) to Supplied
Network ID
Sends a File to the Mailbox Area in the
Cresnet Control System
Retrieves Current File from the Mailbox
Loads Non-Volatile Data Used with a SIMPL
Program
Saves Non-Volatile Data Used with a SIMPL
Program
Update the Control System's Monitor, OPS,
and/or TCP/IP Stack or Update Using the
.upz 'Package'
Alt+O Sends Selected OPS to the Control System
Updates Monitor Low-Level ROM - Used
only by Crestron Technical Support
Sends Touchpanel firmware (.csf file) to
Network ID Supplied
Loads a Data File to Support a Network
Device
Send New Firware to a Plug-in Card
Select a File to be Uploaded or Downloaded
Uploads Selected File Using ASCII
Transfer ASCII File from the Device
Connected to the PC COM Port
Uploads File Using the XMODEM Transfer
Protocol
Downloads File Using the XMODEM
Transfer Protocol
Uploads File Using the XMODEM 1K
Transfer Protocol
Downloads File Using the XMODEM 1K
Transfer Protocol
Loads SIMPL+ to the CEN-OEM
Installation & Operations Guide – DOC. 5728