Table 5-12: Rs-232 C - Teledyne 200A Instruction Manual

Teledyne API Model 200A NO
Table 5-12: RS-232 Command Summary
Commands
? [id]
T [id] LIST
T [id] LIST name or
T [id] name
W [id] LIST
W [id] CLEAR name or
W [id] name
C [id] command
D [id] LIST
D [id] name
D [id] name=value
D [id] LIST NAMES
D [id] ENTER name
D [id] EXIT
D [id] RESET
D [id] RESET RAM
D [id] RESET EEPROM
D [id] PRINT
D [id] PRINT "name"
D [id] REPORT "name"
[RECORDS=number]
[COMPACT|VERBOSE]
V [id] LIST
V [id] name
V [id] name=value
V [id] CONFIG
V [id] MODE
Analyzer Instruction Manual, 02246, Rev. F1
X
Definition
Print help screen. ID is an optional instrument ID number
Print all active test messages
Print single test message "name" from Table 5-15
Print all active warnings
Clear single warning message "name" from Table 5-16
Execute calibration "command" from Table 5-17
Prints all I/O signal values
Print single I/O signal value/state
Sets I/O signal to new "value"
Lists diagnostic test names
Enters and starts 'name' diagnostic test
Exits diagnostic mode
Resets analyzer(same as power-on)
System reset, plus erases RAM. Initializes DAS, NO, NO
readings, calib not affected.
System reset, plus erases EEPROM (RESET RAM actions + setup
variables, calibration to default values). Restores all factory defaults.
Prints properties for all data channels (DAS)
Prints properties for single data channel. Quotes around name are
required.
Prints DAS records for a data channel. Quotes around name are
required. Parameters in brackets are optional.
Print all setup variable names and values
Print individual setup variable value
Sets setup variable to new "value"
Print analyzer configuration
Print current analyzer mode
5-29
, NO conc
x 2