Table 7-10: Activitym - Teledyne 200A Instruction Manual

Teledyne API Model 200A NO
Table 7-10: Activity Matrix for Calibration Equipment and Supplies
Equipment/
Supplies
Recorder
Sample line
and manifold
Calibration
equipment
Working
standard NO
cylinder gas or
NO
2
permeation
tube
Recording
forms
Audit
equipment
Calibrations should be carried out at the field monitoring site. The Analyzer should be in
operation for at least several hours (preferably overnight) before calibration so that it is fully
warmed up and its operation has stabilized. During the calibration, the M200A should be in the
CAL mode, and therefore sample the test atmosphere through all components used during
normal ambient sampling and through as much of the ambient air inlet system as is practicable.
If the instrument will be used on more than one range, it should be calibrated separately on each
applicable range, see Section 7.9. Calibration documentation should be maintained with each
analyzer and also in a central backup
Analyzer Instruction Manual, 02246, Rev. F1
X
Acceptance Limits
Compatible with output
signal of analyzer; min
chart width of 150 mm
(6 in) is recommended
Constructed of PTFE,
glass, or stainless steel
Meets guide-lines and
Section 2.3.2
(Q. A. Handbook)
Traceable to NIST-SRM
Meets limits in traceability
protocol for accuracy and
stability. (Section 2.0.7,
Q. A. Handbook)
Develop standard forms
Must not be the same as
used for calibration
file.
Frequency And Method
Of Measurement
Check upon receipt
Check upon receipt
See Section 2.3.9
(Q. A. Handbook)
Analyzed against NIST-
SRM; see protocol in
Section 2.0.7, Q.A.
Handbook
N/A
System must be checked
out against known
standards
7-13
Action If Requirements
Are Not Met
Return equimpent to
supplier
Return equipment to
supplier
Return equipment/ supplies
to supplier or take corrective
action
Obtain new working
standard and check for
traceability
Revise forms as appropriate
Loacte problem and correct
or return to supplier