Table 9-3: Summary Ofd - Teledyne 200A Instruction Manual

Teledyne API Model 200A NO
Table 9-3: Summary of Diagnostic Modes
DIAG Mode
SIGNAL I/O
ANALOG OUTPUT
D/A CALIBRATION
TEST CHANNEL
OPTICAL TEST
ELECTRICAL TEST
O3 GEN OVERRIDE
RS-232
Analyzer Instruction Manual, 02246, Rev. F1
X
Description
Gives access to the digital and analog inputs and outputs on
the V/F board. The status or value of all of the signals can be
seen. Some of the signals can be controlled from the keyboard.
Table 9-4 gives details on each signal and information on
control capabilities.
NOTE:
Some signals can be toggled into states that indicate warnings
or other faults. These settings will remain in effect until DIAG
mode is exited, then the M200A will resume control over the
signals.
Causes a test signal to be written to the analog output DAC's.
The signal consists of a scrolling 0%, 20%, 40%, 60%, 80%,
100% of the analog output value. The scrolling may be
stopped by pressing the key underneath the % display to hold
that value. The exact voltage values depend on the jumper
settings on the analog output buffer amplifiers.
The analog output is created by 4 digital-to-analog converters.
This selection starts a procedure to calibrate these outputs.
Refer to Section 9.3.3.1 for a detailed procedure.
Allows several different internal voltages to be routed to an
analog output port. Useful for diagnosing intermittent
instrument faults.
Sets the M200A into a known state and turns on an LED near
the PMT to test the instrument signal path. See Section 9.1.3.3
for details on using this test.
Tests just the electronic portion of the PMT signal path. Used
in conjunction with optic test, see Section 9.1.3.2.
This function controls the power to the ozone generator. It
does not indicate status of the generator.
Causes a 1 second burst of data to be transmitted from the RS-
232 port. Used to diagnose RS-232 port problems. See Section
9.1.3.7, 9.3.2 for RS-232 port diagnostic techniques.
9-12